modprobe e1000e InterruptThrottleRate=16000,16000. In this case, there are two network ports supported by e1000e in the system. The default value for each parameter is generally the recommended setting, unless otherwise noted. NOTE: A descriptor describes a data buffer and attributes related to the data buffer.
Feb 04, 2017 · The E1000E driver doesn’t have any bells or whistles to flip on or off, but they could be supported. Stability? No clue, I’ve used the e1000e driver before on an add-in-card ( EXPI9301CT , 8086:10d3 ) and never had any issues, but that’s par for the course these days in Linux and the cheap r8619 are practically as solid. modprobe e1000e InterruptThrottleRate=16000,16000 In this case, there are two network ports supported by e1000e in the system. The default value for each parameter is generally the recommended setting, unless otherwise noted. The e1000e Network driver in RHEL 5 and 6 the link begins to flap intermittently. Environment. Red Hat Enterprise Linux 5, kernel newer than 2.6.18-274.el5; Red Hat Enterprise Linux 6, kernel newer than 2.6.32-131.el6; Intel Corporation 82571EB Gigabit Ethernet Controller; NIC using e1000e driver I have a system running a recently installed RHEL Server 7.3 OS (kernel 3.10.0-514.el7.x86_64), where the e1000e driver is not linked to an on-board I219-LM Ethernet adapter. This condition was found while investigating why the adapter is not working properly. The other Ethernet adapter, which works fine, is a PCI card attached to the MB.
I have an issue with Intel network card 82583V(e1000e driver),the ethernet port detect Hardware Unit Hang and reset unexpected. It seems to occur after few hours during high traffic on the interface. Sometimes the ethernet port go down and never recovery. I tried the latest e1000e driver from Intel(e1000e-2.4.14) ,but the issue is still exist.
Dec 05, 2012 · e1000e - The NVM Checksum Is Not Valid With the recent version of Linux kernel (just a guess) you may discover that your Intel 825** network card (e1000e) is not working anymore and dmesg is displaying an annoying message like this:
I'm currently having a major problem with e1000e (not working at all) in Ubuntu Maverick (1.0.2-k4), after resume I'm getting a lot of stuff in dmesg: [ 9085.820197] e1000e 0000:02:00.0: PCI INT A
I'm using Ubuntu 11.1 (4 Cores, Intel(R) Core(TM) i5-3470S CPU @ 2.90GHz, 8GB , 1000 Mbits/sec Link) with ethernet driver intel e1000e. The manual suggested to use modprobe to change ethernet settings. modprobe e1000e InterruptThrottleRate=3000,3000,3000 The throughput was 4.66 Gbit/sec, which is very close to the result of VMXNET3 on Windows 2008 R2, but almost 150 % better than the new E1000E. In summary the VMXNET3 adapter delivers greatly more network throughput performance than both E1000 and E1000E. Also, in at least this test setup the newer E1000E performed actually lower than the older Using virtio_net For The Guest NIC. The following is done using Debian Lenny, with the 2.6.25 kernel installed from Sid. install the guest OS as per normal, using rtl8139 or e1000 for the guest NIC